Rubber Seal Edge Trim For Trunk Hood Door Anti-impact/Aging Replace 120"/10ft For Sale

Rubber Seal Edge Trim For Trunk Hood Door Anti-impact/Aging Replace 120"/10ft

Car make & model:		Year:
Exterior color:		Condition:
Interior color:		Engine:
Transmission:		Mileage:
Drivetrain:		Fuel Type:
Airbags:		Warranty:	Extended Warranty Quote
VIN#	Vehicle History Report	Documentation:	Owners Manual, Service Manual
Shipping:	Auto Transport Quote	Price:	$30.99

Click HERE for more information about this vehicle.

Material Selection

The bulb portion of a bulb trim seal is usually made of EPDM sponge rubber EPDM provides excellent resistance to weather, ozone, aging, water, and steam. This durable synthetic rubber also remains flexible at low temperatures and is color stable.

EPDM rubber has a high degree of chemical stability, excellent electrical insulation properties and resistance to aging and water resistance, mainly in the following aspects:

1. High aging resistance
· Excellent ozone resistance-EPDM rubber is known as "non-cracking" rubber, and usually rubber has higher ozone resistance.
· Good thermal stability: long-term use at 130 degrees Celsius, interval use or short-term use at 150 degrees Celsius or higher temperature.
· Excellent weather resistance: It can be used in harsh cold, heat, wind, rain and snow.2. Excellent chemical resistance performance:
Due to the chemical stability of EPDM, it does not react with most chemicals. Acid and alkali installation, wraps around the edge of the sunroof glass

Seals the interior and exterior to prevent water, debris, and white-noise intrusion Fits edges

No messy glue, sealant or permanent fixtures needed (i.e screws rivets etc)

Just press on for a snug super tight grip, the flexible trim is metal lined and has grippy inner lips to provide a secure fitment

Heat resistance,cold resistance,dust resistance,ozone resistance anti-aging,waterproof,isolator noi

·Noise Reduction

·Waterproof

·Dustproof

·Soundproof

·UV resistant

How to install:

1.Clean the door edge's any oil, wax & dust. Make sure the door is dry before install.

2.Start from the top, insert the trim onto your door edge until the trim is fully seated.

3.Press the trim with your thumb along the door edge until it is fully seated.

4.Repeat step 3 until all edges are protected.

5.Use scissors to cut away unused trim for other door edges.

When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.